Detecto EU544 Manuel du propriétaire télécharger pdf (Page 8)

ASSEMBLY

Indicator Mounting

To install the indicator on the column bracket, push the latch release (on the 758CSV) down

flush with the back of the indicator and hold. Next, place the screw heads on the back of the

indicator in the large end of the slotted holes in the bracket. Pull down to secure the indicator,

and then release the latch release to lock the indicator to the bracket. To remove the indicator

from the bracket, reverse this procedure.

Load Cell Connection

The load cell cable from the scale connects to the indicator via a 9-pin "D" connector on the

rear panel of the indicator. Plug the cable from the scale to the load cell connector on the back

of the indicator. Use the connector retaining screws to hold the load cell cable connector

securely to the indicator.

Power Supply

To apply power to the indicator using the power supply, plug the power supply’s cable

connector into the power jack on the back of the indicator and then connect the power supply

module into the proper AC electrical outlet. The scale is now ready for operation.

Bracket Mount

Screws

Latch

Release

Latch

Power

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Detecto EU544 Manuel du propriétaire Page 8