Detecto DS-12 Manuel d'instructions télécharger pdf (Page 13)

8529-M635-O1  DS-Series Page 9

CALIBRATION SEAL INSTALLATION

If your DS Series scale is used in a commercial application it must be tested and sealed by

your local weights and measures official. The DS Series is designed to accept a lead and wire

security seal to prevent unauthorized access to the calibration adjustments. Refer to the figure

below for details on the installation of the seal.

 Thread the sealing wire through the hole in the post in the center of the scale as shown.

 Pull the wire tight and install the lead seal.

 The scale housings cannot be separated without damaging the seal.

Lead and Wire Seal

(Bottom View of Scale)

1 2 ... 8 9 10 11 12 13 14 15 16

Pas de commentaire

Detecto DS-12 Manuel d'instructions Page 13