BATTERY OPERATION
Battery operation is a standard feature of the ProDoc Series Wall Mounted Digital Height Rod,
although the batteries are optional (not included). You must first obtain and install four (4) "AA"
size alkaline batteries before operations can begin. Batteries are contained in a battery holder
inside the display. Access is via a removable cover on the back of the display.
Installation / Replacement
To install or remove the batteries, the following steps should be followed:
1. If wall mounted, remove the display by sliding it up and away from Display Wall Bracket “B”.
2. Turn the display over so that the keypad is facing down on the desk or table.
3. Remove Display Wall Bracket “A” and
locate the rectangular battery cover on the
back of the display.
Figure No. 10
Push in
and lift
here.
Battery
Cover
4. To install or replace the batteries, first
remove the battery cover by pushing in on
the tab and lifting it up. See Figure No. 10.
5. If installing new batteries, proceed to step
6. If replacing the batteries, remove all
four (4) batteries from the battery holder,
then proceed to step 6.
6. Install the four (4) new “AA” size batteries
in the battery holder, noting the polarity
markings located in the battery holder.
See Figure No. 11.
Figure No. 11
7. Replace the battery cover (it will click
when locked in place) and return the
display to the upright position.
8. Press the ON/OFF key.
9. The display will turn on, show all digits
then show 11)0
cm.
10. If the display did not turn on, remove the
battery cover and check for one or more
improperly positioned batteries.
11. The display is now ready for normal
operation.
NOTE!
y If the display is wall mounted, follow steps 8 to 10 on page 5 to re-install on the wall.
y Follow steps 3 and 4 on page 6 if using the display on a desk or table.
Low Battery
When the batteries are near the point they need to be replaced, the display will show BAt. If the
battery voltage drops too low for accurate measurements, the display will automatically shut off
and you will be unable to turn it back on. When the BAt message is displayed, the operator
should replace the batteries.
Automatic Shutoff
The Automatic Shutoff feature will turn the display off after one (1) minute of inactivity to
prolong battery life. To turn the display back on, you simply press the ON/OFF key.
0044-M372-O1 y DHRWM
Page 8
(86 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels