Detecto DHRWM Manuel du propriétaire télécharger pdf (Page 6)

INSTALLATION

Mounting the Height Rod

1. Choose the location to mount the height

rod on the wall. The location should be

free of temperature extremes and water. It

should be where it is within easy reach of

the operator.

2. Make certain the structure and mounting

hardware are of sufficient strength to

support the height rod. The mounting

bracket should be securely fastened to the

wall so that it cannot break loose from the

mounting surface.

3. Referring to Figure No. 1 and using the

height rod as a template, place the height

rod against the wall and mark the holes to

use to mount it. The lower mounting hole

should be 6 13/32 inches (162.5 mm) from

the floor and the upper mounting hole

should be 30 25/32 inches (782.0 mm)

from the lower hole.

4. Remove the height rod and drill two (2)

13/64” (5 mm) holes in the wall for the

mounting wall anchors.

5. Insert the wall anchors in the wall until they

are flush with the wall.

6. Place the height rod against the wall and

insert the two (2) M3.0x25 screws through

the bracket and into the wall anchors.

7. Partially tighten the screws to hold the

height rod in place.

8. Make sure the bottom of the height rod is

25/64 inch (10 mm) from the floor and then

tighten the screws to secure the height rod

to the wall.

Floor

6 13/32”

(162.5 mm)

30 25/32”

(782 mm)

25/64”

(10 mm)

Figure No. 1

0044-M372-O1 y DHRWM

Page 4

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire