Detecto DHRWM Manuel du propriétaire télécharger pdf (Page 5)

UNPACKING

Remove the height rod, display, hardware pack and other components from the shipping carton.

After removing from the carton, check for any damage that may have taken place during

shipment. Keep and use the original carton and packing material for return shipment if it should

become necessary. The purchaser is responsible for filing all claims for any damages or loss

incurred during transit. Remove all plastic wrapping, foam fillers and cardboard material from

the height rod, display and other components. You should have the following components:

(1) Detecto Wall Mounted Digital Height Rod (DHRWM)

(1) Remote Display

(1) Display Wall Bracket “A”

(Includes four (4) feet for desk or table mounting)

(1) Display Wall Bracket “B”

(1) Hardware Pack, containing:

(4) M3.0x25 Screws

(4) Plastic Wall Anchors

M3.0x25 Screw

Plastic Wall Anchor

ASSEMBLY

The DHRWM does not require any assembly. After installing batteries, the DHRWM is ready for

wall mounting and operation.

BATTERY INSTALLATION

1. Turn the display over so that the keypad is facing down and locate the rectangular battery

cover on the back of the display.

2. Remove the cover, install four (4) “AA” size batteries

and then replace the cover.

3. Turn the display over to the normal operating position.

4. Make sure the height rod is in the starting position.

5. Press the ON/OFF key to turn the display on.

6. The display will turn on, show all digits then show 11)0

cm.

7. If the display did not turn on, remove the battery cover and check for one or more improperly

positioned batteries.

8. The digital height rod and display are now ready to be installed.

See page 7 for detailed instructions on installing the batteries.

0044-M372-O1 y DHRWM

Page 3

1 2 3 4 5 6 7 8 9 10 11 12

Pas de commentaire

Detecto DHRWM Manuel du propriétaire Page 5