Detecto DHRWM Manuel du propriétaire Page 11

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 12
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 10
OPERATION
Keypad Functions
DO NOT operate the keypad with pointed objects (pencils, pens, etc).
Damage to keypad resulting from this practice is NOT covered under warranty.
The UNITS key is used to change the
height units between feet/inches and
centimeters.
With the display off, pressing the ON/OFF
key will apply power and turn on the
display. If the display is on, pressing it will
turn the display off.
Figure No. 12
Annunciators
The annunciators are turned on to indicate that the display is in the mode corresponding to the
annunciator label or that the status indicated by the label is active.
The ' " annunciators are turned on when the displayed measurement is in feet and inches.
The cm annunciator is turned on when the displayed measurement is in centimeters.
Measuring Patient’s Height
IMPORTANT! The digital height rod must be returned to its “starting position”
before every use (the inner sliding tube must be down completely inside the
outer stationary tube) and the headpiece folded flat against the stationary tube.
Otherwise, ----- will be displayed.
1. Make sure the height rod is in the starting position.
2. Press ON/OFF key.
3. The display will turn on, show all digits then show 110.0
cm.
4. Press UNITS key to toggle between centimeters and feet/inches. The cm (centimeters)
or ( ' " ) (feet/inches) annunciator will turn on to show which measurement unit is active.
5. Grasp height rod at the hinge pin (see Figure No. 13) and
raise it well above patient’s head and then lift headpiece to
horizontal position.
Figure No.13
6. Patient may now step under the height rod headpiece.
7. Carefully lower height rod until headpiece rests on top of
patient’s head.
8. Read and record height of patient.
9. While holding headpiece horizontal, raise height rod well
above patient’s head.
10. Patient may now step away from height rod.
11. Return height rod to starting position.
12. To turn display off, press ON/OFF key.
NOTE! If the DHRWM is not used again within one (1) minute, the Automatic Shutoff feature
will turn the display off.
0044-M372-O1 y DHRWM
Page 9
Vue de la page 10
1 2 ... 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire